Pressure Sensor (0 .. 700 kPa)

The pressure is measured via a pressure port located next to the switch on the sensor.
You can attach a plastic tube or a valve with Luer-lock connectors. You can also attach the 20-ml plastic syringe included with the sensor directly to this port.

Technical specifications:

Measurement ranges: 0 .. 130 kPa / 0 .. 700 kPa
Accuracy: ±0.1% (full scale range)
Included: 20ml plastic syringe, 2 plastic tubes (5 & 45cm), three-way valve with Luer- lock connectors, two Luer-lock connectors
pressure: 1000 kPa (more pressure can cause permanent damage)
Maximum measurement frequency: 100 kHz (CoachLab II+, WiLab) / 1 MHz (VinciLab 2)
Required: One sensor cable (BTsc_1 or BTsc_1Short)
Warrantee: 3 years

All technical specifications of the sensor are descibed in the product manual, see downloads.

The Pressure sensor can be used for physics and chemistry experiments, such as:

Measurements of pressure changes in gas-law experiments, Boyle’s and Gay-Lussac’s laws
Measurements of vapor pressure of liquids
Measurements of reaction rates as a gas is produced in chemical reactions
Measure atmospheric air pressure

A ‘P4272-1K BT sensor cable, single’ is required to connect the sensor to the interface.
Please check whether you already have this cable in your stock.